or
)
next to the query you want to run (see figure below). This topic explains how to use the query editor from the Risk module to run any type of previously created query and refresh its results. This allows you to monitor any changes to the results as the projects underway progress.
1. Access the Risk module.
2. In the Queries section, click the List Queries link.
3.
In the Project Queries section, click Run (or)
next to the query you want to run (see figure below).
Note: The map icon ()
indicates that the results of the query will be displayed on a map, the table
icon () indicates that they will be displayed
through a table, and the integrated overview icon (
)
indicates that they will be displayed through the integrated overview, which is
only available for queries consolidated by asset.
In the case of queries saved to be shown on maps, the option to display maps must be enabled in the Display Options section of the Administration module. An internet connection is also required, otherwise an alert will appear and the results will not be displayed.
Remember that queries must be edited and saved again to change the way their results are shown.
The system displays the results of the query that was run.
4. Click Refresh Results so that the latest results can be displayed.
The system refreshes the results. The date and time the query was lasted updated can be viewed in the upper right corner (see figure below).
5. Click the List Queries link in the upper right corner to return to the list of queries.