1. Access the Continuity module.
2. Select Procedure Repository from the Plans option on the menu.
3. In the List of Procedures section, click Edit next to the procedure you want to edit.
If the procedure was previously published, the system requests confirmation to edit the procedure (see figure below).
4. Click Edit Procedure to confirm. If you want to quit the operation, click Cancel.
The status will change from "Published" to "Being Edited", and the system displays an area where changes can be made to the procedure (see figure below).
5. When finished, click Save. If you want to quit the operation, click Cancel.
The system displays a success message.